![]() It is possible to test programmatically for the existence of a live upstream using Plink. The one special case is that PSCP and PSFTP will never act as upstreams. command line, you can used putty -telnet or putty -ssh to open sessions from the command line but we are interested in putty -load. For example, if PSCP or PSFTP loads a configuration with sharing enabled, then it can act as a downstream and use an existing SSH connection set up by an instance of GUI PuTTY. ![]() I have referred to ‘PuTTY’ throughout the above discussion, but all the other PuTTY tools which make SSH connections can use this mechanism too. because it needs to do its own authentication using a special private key) then you can untick one or the other of these boxes. because you definitely need it to close promptly) or not to be a downstream (e.g. (These boxes only take effect if the main ‘Share SSH connections if possible’ box is also ticked.) By default both of these boxes are ticked, so that multiple PuTTYs started from the same configuration will designate one of themselves as the upstream and share a single connection but if for some reason you need a particular PuTTY configuration not to be an upstream (e.g. In case you need to configure this system in more detail, there are two additional checkboxes which allow you to specify whether a particular PuTTY can act as an upstream or a downstream or both. This is similar to the effect you get with port forwarding or X11 forwarding, in which a PuTTY whose terminal session has already finished will still remain open so as to keep serving forwarded connections. The upstream PuTTY can therefore not terminate until all its downstreams have closed. Here’s how I use Putty with SuperPutty to enable multi tabs. ![]() Using SuperPutty/MTPutty with Putty makes life easier. But what it lacks is multi-tab support when you have to work on multiple devices/windows at the same time. ![]() All subsequent PuTTYs which reuse the connection are referred to as ‘downstreams’: they do not connect to the real server at all, but instead connect to the upstream PuTTY via local inter-process communication methods.įor this system to be activated, both the upstream and downstream instances of PuTTY must have the sharing option enabled. Putty is no doubt the best telnet/ssh tool we have. When this mode is in use, the first PuTTY that connected to a given server becomes the ‘upstream’, which means that it is the one managing the real SSH connection. ![]() For example, selecting ‘Duplicate Session’ from the system menu will launch another session on the same host, and if sharing is enabled then it will reuse the existing SSH connection. Then, whenever you start up a PuTTY session connecting to a particular host, it will try to reuse an existing SSH connection if one is available. To enable this feature, just tick the box ‘Share SSH connections if possible’. The SSH-2 protocol permits you to run multiple data channels over the same SSH connection, so that you can log in just once (and do the expensive encryption setup just once) and then have more than one terminal window open.Įach instance of PuTTY can still run at most one terminal session, but using the controls in this box, you can configure PuTTY to check if another instance of itself has already connected to the target host, and if so, share that instance's SSH connection instead of starting a separate new one. The controls in this box allow you to configure PuTTY to reuse an existing SSH connection, where possible. I'm looking for a solution to make the PuTTY windows persist (e.g.Previous page next page 4.18.5 Sharing an SSH connection between PuTTY tools I'm working in various Linux environments through PuTTY connections which break from time to time. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |